For abrasion-resistant and transparent "polymers" or "polishes" with Devo Gloss.

Purpose:for wear-resistant and transparent "polymers" or "polishes" with Devo Gloss.

Application on: calciferous floors, such as marble, travertine, Burgundy leidal, honed bluestone, terrazzo, etc.

Untreated/newly laid floors:

• If necessary, remove cement residue.
• If no cement residue, clean with Devo Strongclean.
• If unevenness (burrs, etc.), first saturate the floor with water! Then wet sand the floor with the Devoboy machine + waterproof sanding discs. Sand with fine grains 120, 220 and 400. Clean the floor with the Devo rinsing  and suction machine.
• For pore filling in depth, it is recommended to treat the floor with Devo Marble Renewer.

Treated/previously laid floors:

• If the floor was treated with a protective layer, remove it first with the designated Devo stripper! Paint and varnish: use Devo Varnish Strip. Acrylic polymers and polish: use Devo Polymstrip. Glue carpet and PVC remnants: use Devo Gluestrip.
• If no Devo stripper is applicable, scrub the floor thoroughly with Devo Strongclean.
• If small bumps (burrs, etc.), wet sand the floor with the Devoboy machine + drive plate + waterproof sanding discs.
• Sand with fine grits 120, 220 and 400. Clean the floor with the Devo rinse and vacuum machine.

Follow-up steps:

• When the floor is completely dry apply the ready-to-use Devo Gloss thinly and evenly with a wax applicator (mop). Do not rub in! Devo Gloss is a self-gloss wax and dries without streaks. Dry after about 1 hour at room temperature. Then apply a second coat crosswise. After drying, the gloss level can be increased/restored by polishing the floor with the Devoboy machine + white pad.
• Periodic maintenance: Devo Dry Clean Set and Devo Gloss dilution for mop cleaning.

Please also refer to Devo product labels, machine operating instructions and pay attention to safety instructions!