One-component elastic, solvent-free and water-free hybrid MS polymer adhesive for multilayer parquet and narrow solid strips.

Especially for bonding multi-layer parquet directly to concrete, screed, anhydrite, fermacell boards and wood. Also suitable for laying on underfloor heating and tiled floors. For gluing wide solid strips, we recommend Devo Glue MS 250 or PU 500 2C. 

• Ideally suited for installation of factory-finished parquet floors;
• Suitable for screeds with underfloor heating;
• Does not contain water, so no expansion of the wood;
• Solvent-free;
• Good spreadability;
• Semi-elastic, approx. 50 Shore.

Substrate preparation: the substrate must be clean, dry, grease-free and free from loose particles. Always check the moisture content of the substrate and wood with appropriate instruments (max. permissible moisture content of cement screeds 2 %, anhydrite max. 0.5 % residual moisture). Do not glue on screeds that are not protected against rising damp. A vapour-proof foil must always be installed. Pre-treat dusty or silty screeds with Devo Primer Compact or Devo Primer Express PU. See also our general guidelines for parquet installation on various substrates and the Devo Glue guide. 

Product preparation: bring the product to room temperature before use. Devo Glue MSP 140 1C is ready for use. 

Application: use the appropriate glue comb depending on the substrate and the parquet to be installed. Work in strips of maximum 60-80 cm wide. Remove the protective film on the adhesive, apply a quantity of adhesive and spread with a glue comb. Always keep the glue comb straight during gluing. In this way you will transfer the profile of the adhesive teeth to the floor in an even adhesive bed. The comb should always "scrape" well. There should be no adhesive on the substrate between the adhesive beads. Do not apply more adhesive to the substrate than you can cover with parquet in 30 min. When finishing work, put the protective film back on the adhesive. Residual product will then remain usable for a long time. 

Drying time: 2 - 3 mm adhesive thickness per 24 hours, can be spread after approx. 12 hours. 

Finishing: after 12 hours, also suitable for laying pre-finished parquet. Sandable after 48 hours. 

Processing temperature: 5 - 35 °C. 

Consumption: 800 - 1400 gr/m². 

Tool cleaning: Uncured product: Devo Wet Wipes. Cured product: mechanically with spatula and/or scouring pad. 

Shelf life: minimum 6 months in original, tightly closed packaging. Storage temperature between 5 and 25°C. 

Waste: dispose of residues and empty packaging according to local authority regulations. 

Keep out of children's reach. In case you need to consult a doctor, keep the container or label at hand. Safety data sheet available on request.