01 July 2021

Renew, clean, pore fill and polish marble in one pass with Devo Marble Renewer on: untreated/newly laid floors. Not scratched.

Learn more about marble renewal, cleaning, pore filling and polishing all at once with Devo Marble Renewer on: untreated/newly laid floors. Not scratched.

Purpose: to renew marble, clean, fill pores and polish in one pass with Devo Marble Renewer on: untreated/newly laid floors. Not scratched.

Application on:all calciferous natural stone floors such as: marble, travertine, bluestone, Solnhofer, white stone, Burgundy leidal, Jura, etc..

  • Saturate the surface to be treated with water and wash away all dirt. Remaining sand grains can cause scratches during the treatment!
  • If unevenness (burrs, etc.) saturate the floor with water again! Then wet sand the floor with the Devoboy machine + waterproof sanding discs. Sand with fine grains 120, 220 and 400. Clean the floor with the Devo rinsing and vacuuming machine.
  • By applying Devo Marble Renewer you do four operations in one go: remove cement residue, clean, fill pores and polish!

Procedure:

  • Sprinkle the floor with water and sprinkle with Devo Marble Renewer powder. Maximum of 5 to 6 m² at one time. Then polish with the Devoboy machine + machine agitation + white pad. A yellowish cream is produced that should remain constant. Too dry: add a little water. Too wet: add powder. Per 5 to 6 m² ± 20 to 25 minutes of overlapping polishing. After the water-resistant gloss has developed (to be checked with a floor squeegee), rinse thoroughly with water (Devo rinse-  and suction machine). When the surface is completely treated, mop the floor. After drying, machine polish with a dry white pad. The gloss depends on the lime content of your floor. For polishing smaller areas and vertical sections, make Devo Marble Renewer cream in a jar. Then mix 2 parts powder with 1 part water. Apply the cream to the areas to be treated with sponge or brush. Polish with small thick white pad.
  • In case of intensive use, it is recommended to immediately protect the floor additionally with Devo Gloss WITHOUT pre-cleaning with Devo Strongclean.

Periodic maintenance:

  • Devo Dry Clean Set
  • Devo Marble Renewer for local treatment of dull spots.

Please also refer to the Devo products' labels, machine operating instructions and pay attention to safety regulations!

Finishing and protection products -

024250
2 Variants

Finishing and protection products -

024240
2 Variants

Sanding, polishing and other pads -

32102016

Accessories for Woodboy machines -

320032

Webshop powered by Marcando